открытый полуприцеп с тентом

Meusburger 2-Achs-Jumbo-Tiefbett mit Planenaufbau

Chassis:
- Steel frame welded construction with front and rear frame cranking and low bed without rear chamfer
- Gooseneck + fifth wheel plate 225 mm
- Low bed designed for a point load of 25 t over 5 m
- Outer frame closed on the outside with welded lashing rings for securing loads
- Interchangeable 2" kingpin
- Rear end plate functions as underrun protection
- Rear mounting rail for aluminum ramps

Axles and Tyres:
- BPW low loader axles, each with 10 t axle load, air bellows diameter 360 mm
- Air suspension with lifting and lowering function, lift 220 mm (-60/+160 mm)
- Wabco SmartBoard with ECAS function for 2 coupling heights + 100 mm
- S-cam brake 300/200 mm, asbestos-free brake linings
- Automatic slack adjusters
- IVTM tyre pressure monitoring
- 9 tires 235/75 R 17.5, tubeless

Steering:
- 1st and 2nd axle hydraulically forced steered via king pin coupling

Floor:
- Multi-layer glued plywood floor, thickness 27 mm, flush with the outer frame and longitudinal beams
- Reinforced underneath with GRP coating
- 12 pairs of lashing rings welded into the outer frame (8 pairs RUD, 8 t)

Front Wall:
- 25 mm aluminum hollow profiles extending up to the lower roof edge, with integrated tarpaulin tensioning device

Sliding Tarpaulins:
- Sliding tarpaulins on both sides with welded vertical and horizontal belts (approx. 600 mm spacing) and stainless steel tension locks
- Adjustable over-centre curtain straps up to a loading width of 4,000 mm including tarpaulin extension with snap fasteners and Velcro
- Tarpaulin extension in the direction of travel: 300 mm, in height: 750 mm
- Including eyelets for loose tarpaulin extension
- 1 pair of vertical tarpaulin pockets, approx. 1,000 mm in length, positioned in the low bed at the front cranking

Rear Wall:
- Steel rear portal frame with lateral tarpaulin fasteners
- Aluminum double-wing rear door, 25 mm thick
- Both door leaves can be fully swung open with door retainers
- Each door leaf equipped with an aluminum double-joint hinge and two recessed grip pockets
- Rear portal extendable by 1,250 mm to the left and right

Centre Pillars:
- 3 pairs of continuously slidable folding pillars
- Pillars are movable along the entire length via trolleys
- Centre pillars in the low bed can also be fixed on the rear platform

Roof:
- EDSCHA sliding roof (galvanized) with cross bows, movable in both directions
- Rear portal crossbar can swing out
- PVC tarpaulin roof without customs seal
- Manually operated hydraulic lifting roof on both sides, 450 mm lift
- Lifting roof can be driven in elevated positions at the front (9x50) and rear (9x50)
Fodpfjyiyy Ujx Acyepc
- Including tarpaulin extension and tarpaulin skirt at the rear
- Roof at front wall can be cranked out 900 mm each side

Accessories:
- 4 wheel chocks
- 2 ECE plates
- 1 spare wheel holder
- Extendable warning boards (removable at front and rear, with socket) incl. position lights up to 4,000 mm loading width, additional locks at 3,000/3,400/3,700 mm. 1 at the front cranking, 1 at the end of the frame, plus 1 at the end of the low bed – only extendable bracket for swapping the rear warning boards
- Storage for the 4 warning boards at the top inside right and left of the front wall
- 1 aluminum ladder with holder, 2,500 mm long, on the front wall
- 2 rows of self-locking aluminum slats, with hanging options at 100/200/300/400/500/1,000/1,500/2,000/2,500 mm
- Steel mudguards with splash flaps
- 1 night parking board and 1 ADR plate on the rear wall
- BEKAMAX central lubrica

Объявление было переведено автоматически, в связи с чем могут иметь место некоторые ошибки перевода.