Низкорамный прицеп

MÜLLER-MITTELTAL T4, Luftfed., hydr. Klapprampe, Baggerstiel.

* T 4:
* Wabco EBS-E (electronic braking system)
* RDÜ tire pressure monitoring system
* Emergency release device for spring brake cylinders
* Drum brakes
* 4 x 11 t Gigant axles
* Air suspension with lift/lower system and RtR valve
* Smard board for payload weight determination
* Warning sign packages front & rear
* Reflective contour tape on the sides and rear
* Rear removable beacon light
* LED lighting
* Straight drawbar with 50 mm towing eye and continuously variable height adjustment
* Tool box made of powder-coated sheet steel and spare wheel holder in basket design, fitted on the right side
* Front closed single fender made of plastic
* Rear straight steel mudguard aprons, each with spray protection (spray suppression)
* Side underrun protection
* Turntable platform extended by 520 mm with 45° corners and three integrated storage compartments incl. lids, lockable
* Chassis made of high-strength fine-grain steel
* Flooring above turntable platform made of 50 mm and in low-bed platform of 60 mm softwood
* Outer planks of access ramps made of hardwood
* 4 stake pockets per side (stakes not included), each with 2 t lashing point
* Lashing package consisting of: 2 lashing eyes 6.4 t at the front left and right on the main frame of the turntable platform
* On each side front and rear: 2 pairs of 13.4 t lashing rings on the outer frame, and 4 pairs of 10 t lashing rings per side, swiveling and retractable
* Loadable in all directions and recessed into the outer frame
* 2 pairs of 6.4 t lashing rings in the excavator arm recess
* 8 pairs of galvanized folding outriggers for 3 m total width (except for the rear slope)
* Widening planks stored in a box on the left side
* Excavator arm recess above the rear axle up to the start of the ramp incline: approx. 2,100 x 740 x 190 mm
* Mechanical support legs at rear
* Hydraulic folding ramps with hydraulically extendable tip section approx. 4,650 x 720 mm incl. hydraulic ramp lateral shift & load holding valve
* Load area above turntable: approx. 2,990 x 2,520 mm
* Rear loading area: approx. 6,780 x 2,520 mm
* Loaded deck height: approx. 890 mm, +/- 20 mm (incl. 860 mm ramp incline)
* Flow divider installed
* Chassis, turntable, access ramps, folding outriggers, and mechanical support legs hot-dip galvanized
* Axles, drawbar, air tanks and turntable painted in black
* Tires: 235/75 R 17.5
* New vehicle without initial registration with manufacturer’s warranty
* Errors and prior sale reserved
Isdpsl Tphrsfx Afrjbd
* Available from CW 07/2026

Объявление было переведено автоматически, в связи с чем могут иметь место некоторые ошибки перевода.