Прицеп с рабочей платформой

MÜLLER-MITTELTAL T4, Luftfed., hydr. Klapprampe, Baggerstiel.

* T 4:
* Wabco EBS-E (electronic braking system)
* RDÜ tire pressure monitoring system
* Emergency release device for spring brake cylinders
* Drum brakes
Hedpfx Ahol Tik No Henk
* 4 x 11 t Gigant axles
* Air suspension with lifting and lowering device and RtR valve
* SmarD on-board system for load weight determination
* Warning sign packages front & rear
* Reflective contour tape on sides and rear
* Removable rotating beacon at the rear
* LED lights
* Straight drawbar with 50 mm towing eye and infinitely adjustable height
* Tool box made of powder-coated steel and spare wheel holder in basket design, mounted on the right side
* Enclosed plastic single fenders at the front
* Straight steel mudguards at the rear, each with spray suppression (anti-spray system)
* Side underrun protection
* Turntable platform extended by 520 mm with 45° corners and 3 integrated storage compartments incl. cover, lockable
* Chassis made of high-strength fine-grained steel
* Floor over turntable platform made of 50 mm softwood, in the low-bed platform made of 60 mm softwood
* Outer planks of the loading ramps made of hardwood
* 4 stake pockets on each side (no stakes included) with simultaneous 2 t lashing point per pocket
* Load securing package consisting of: 2 lashing points 6.4 t at the front left and right on the main frame of the turntable platform
* 2 pairs of 13.4 t lashing rings each at the outer frame front and rear, as well as 4 pairs of 10 t lashing rings per side, swiveling and retractable
* Loadable in all directions and recessed into the outer frame
* 2 pairs of 6.4 t lashing rings in the excavator arm rest area
* 8 pairs of galvanized swing-out marker boards for 3 m total width (not at the rear slope)
* Widening planks stored in a compartment on the left side
* Excavator arm rest above rear axle up to end of approach ramp approx. 2,100 x 740 x 190 mm
* Mechanical drop-down supports at the rear
* Hydraulic folding ramps with hydraulically adjustable tip, approx. 4,650 x 720 mm incl. hydraulic lateral ramp shifting and load-holding valve
* Loading area across the turntable: approx. 2,990 x 2,520 mm
* Rear loading area: approx. 6,780 x 2,520 mm
* Loading height loaded: approx. 890 mm, +/- 20 mm (incl. 860 mm approach slope)
* Flow divider installed
* Chassis, turntable, access ramps, flip-out marker boards and mechanical drop-down supports hot-dip galvanized
* Axles, drawbar, air tanks, and turntable painted in black
* Tires: 235/75 R 17.5
* New vehicle without first registration, with manufacturer warranty
* Subject to errors and prior sale
* Immediately available ex Egestorf on the A7

Объявление было переведено автоматически. Возможны ошибки перевода.