Трал низкорамный

Fliegl VTS 400

Additional information
Chassis: Low-bed semi-trailer
Steel welded construction
Turntable with heavy-duty ball bearing
Foldable rear supports
2 chock blocks with holder
Aluminum side impact protection
Splash guards at the rear, covering the entire width
Partial fender in front of the 1st axle
Extendable widening sections to 3,000 mm (not in the rear slope)
(However, the track width of the construction machinery or vehicles to be transported must not exceed
the outer frame width of 2,550 mm)
Storage compartment for wooden planks in the middle of the loading area
Wooden planks 70 mm for widening to 3,000 mm
Lashing points: Low-bed trailer
1 pair of lashing points on the gooseneck, each 5 tons
9 pairs of lashing rings recessed on the top and sides of the outer frame, each 10 tons
2 x at the front on the gooseneck
7 x in the low bed
6 pairs of lashing holes in the outer frame of the low bed, each 5 tons.
(For attaching lashing straps)
Coupling device: Trailer turntable
Drawbar with tested 50 mm towing eye
Axles + Suspension
SAF drum brake axles
Axle/chassis laser-aligned to reduce tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearing and mechanical incl.
Axle load compensation at the front and rear (rocker arm compensation)
Wheels and tires
235 / 75 R 17.5
As per manufacturer's choice
Steel rims in twin arrangement, factory silver
Braking system
2-circuit compressed air braking system
Spring-loaded parking brake
2 fail-safe coupling heads at the front, with connecting lines to the tractor unit
ABS and ALB, with ABS connector at the front, with connecting cable
Note: The trailer may only be towed by tractor units that ensure the effectiveness of the ABS!
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red side marker lights at the rear
1 LED rotating beacon with holder, switched via parking light (beacon can be removed)
Lajdpfx Aei Ri Izep Isc
2 pairs of warning signs, double LED illuminated and extendable to 3,000 mm
2 x 7-pole fail-safe plugs at the front, with connecting cable
Floor
Gooseneck at the front with steel/non-slip plate covering
Followed by 70 mm soft wood floor, steel/non-slip plate covering in the wheel arch area
Rear slope with 70 mm soft wood floor
Ramps
Steel ramps 2,800 mm long, 750 mm wide, laterally adjustable
Covered with wood
Hydraulically operated via tractor unit auxiliary drive with throttle valve, operation on the left side
Hydraulic connection with Schnell coupling NW 10/3, incl. connecting hose
Operating instructions
An exemption permit is required for an axle load of 10,000 kg, only indivisible loads are permitted!!!
The specified total weight is technically possible, but depending on the load, the total weight may not be reached while observing the permissible axle/support and saddle loads. (Poor driving and tracking behavior may occur due to incorrect load distribution)
Registration country/signage
Registration country: Germany
With Dekra approval and certificate (according to §13 EG - FGV)
24/7 service hotline included
Prepared for license plate holder, two-line
Contour marking with reflective tape according to ECE R 048, white on the sides and red at the rear
Painting
Frame DB 7350 Novagrau
10-year warranty against rust
Drawbar galvanized or black, as per manufacturer's choice
Ramps hot-dip galvanized

Объявление было переведено автоматически. Возможны ошибки перевода.