Трал низкорамный

Fliegl TPS 118 Bau m Heckanschrägung

Further information
Chassis central axle trailer
Welded fine-grained steel construction
6 pairs of lashing eyes bolted to the outside of the floor/outer frame, 5 tons each
2 pairs of lashing eyes additionally bolted to the floor, 5 tons each in the corners
Gear support foot at the front
Folding rear support
2 wheel chocks with holder
Steel underride guard
Rear spray flaps across the entire width
Quarter-shell mudguards
1 plastic tool box, with shelf, w=620/h=360/t=440 mm, lockable with a padlock. (lock not included in scope of delivery)
Towing device central axle trailer
Towing bar with tested 40 mm towing eye
Height-adjustable drawbar via spindle, max. adjustment range 300 mm
Axles + suspension
Drum brake axles, manufacturer's choice
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load compensation (rocker compensation)
Wheels and tires
235 / 75 R 17,5
manufacturer's choice
Factory silver steel rims
Brake system
2-line compressed air brake system
Hand spindle parking brake
Integral air reservoir
2 non-interchangeable coupling heads at the front, with connecting cables to the motor vehicle,
Hedpsi Rixrjfx Andon
ABS and ALB, with ABS plug at the front, with connecting cable
Electrical system
24 volt, multi-chamber lights, amber LED lighting at the side
2 white position lights at the front
2 white/red lane departure lights at the rear
2 x 7-pin interchangeable plugs at the front, with connecting cable,
Floor
Steel/ checker plate floor for high point load capacity
Note: Slight floor corrugation possible due to welding distortion!
Platform length approx. 5,200 mm
Rear sloping to approx. 900 mm
Front wall / front corner stanchions
25 mm aluminum hollow profile, 400 mm high,
Drop sides
25 mm aluminum hollow profile, 400 mm high, foldable and removable
Rear wall / rear corner stanchions
1 pair of steel stanchions attached to the frame and with bracket for locking the drive-on ramps, drive-in width approx. 2,430 mm
Drive-on ramps
2 steel ramps 2,300 mm long, 510 mm wide, can be moved sidewayswith grab handle on the ramps
covered with 3 toothed steel rails
With gas pressure jack for one-man operation
Country of registration/plates
Country of registration: Germany
24/7 service hotline
Prepared for single-line license plate holder
Contour marking with reflective strips in accordance with ECE R 048, white on the sides and red on the rear
Paintwork
Hot-dip galvanized frame incl. passivation
15-year warranty against rusting through
Front wall aluminum
Side wall anodized aluminium
Drive-on ramps Hot-dip galvanized
Attention! These are archive pictures.

Объявление было переведено автоматически. Возможны ошибки перевода.