Трал низкорамный

Fliegl DTL-S 300 Agrar

Further Information
Chassis Low-Loader Trailer
Steel welded construction
Turntable with heavy-duty slew ring
Foldable rear supports
2 wheel chocks with holders
Full-width rear spray flaps
1 plastic toolbox with shelf, b=620/h=360/t=440 mm, lockable with padlock (padlock not included)
Preparation for widening to 3000 mm (holes in outer frame, not in rear slope)
Lashing Points Low-Loader
1 pair of lashing cutouts recessed in the front longitudinal beam kink, each 10 t
7 pairs of lashing mushrooms recessed on top and side of outer frame, each 10 t
- 1x at the front kink
- 5x in the low-bed area
- 1x in the rear slope
12 pairs of lashing holes in outer frame, each 5 t (for tie-down strap hooks)
- 5x front kink, 6x low-bed, 1x rear slope
Drawbar & Turntable Drawbar Coupling
Drawbar with tested 40 mm towing eye
Axles + Suspension
Drum brake axles, manufacturer’s choice
"Axle/Chassis laser aligned" reduces tyre wear and fuel consumption
Parabolic suspension with maintenance-free steel-rubber bearings and mechanical axle load balancing (rocker balancing)
Wheels and Tyres
235 / 75 R 17.5", manufacturer’s choice
Steel twin wheels, factory silver
Braking System
2-line air brake system
Bdedpfx Aox A Amcjffsk
Spring-loaded parking brake
2 front anti-mix couplings with connecting hoses to towing vehicle, lines extended by approx. 60 cm
Without ABS, but with mechanical ALB, then max. 60 km/h permitted
Electrical System
12 Volt, multi-chamber lights, no yellow LED side lighting, side reflectors
2 white position lights at front
2 white/red lane marker lights at rear
1 x 7-pin 12 Volt plug at front with connection cable, extended by approx. 60 cm
1 LED beacon with bracket, controlled via parking lights (removable beacon)
Floor
Front kink with steel/tread plate covering
Storage box recessed in the transition slope to front kink
Next with 70 mm softwood flooring, in wheel arch area steel/tread plate covering
Rear slope with 70 mm softwood floor
Low-bed loading platform including rear slope: 5900 mm
Loading Ramps
Steel ramps, 2,800 mm long, 750 mm wide, laterally adjustable
Wooden inlay
With spring assistance
Operation Notes
For 10,000 kg axle load, an exemption permit is required, only indivisible loads allowed!
The specified gross weight is technically feasible; depending on the load, the permissible gross weight may not be achievable while complying with allowable axle/support/kingpin loads. (Improper load distribution may impair driving and tracking)
Country of Registration / Plates
Country of registration: Germany
With Dekra inspection and certificate, for max. 60 km/h approval, towing vehicle LoF (Switzerland: max. 40 km/h allowed)
Prepared for two-line license plate holder
Without contour marking / reflective strips per ECE R 048
Paintwork
Frame: hot-dip galvanized incl. passivation (15-year warranty against perforation corrosion)
Drawbar: galvanized or black, manufacturer’s choice
Loading ramps: hot-dip galvanized

Объявление было переведено автоматически, в связи с чем могут иметь место некоторые ошибки перевода.