Низкорамный прицеп

MÜLLER-MITTELTAL T4 Radmulden / luftgefedert

* T4 RM 40.0:
* Wabco EBS-E (electronic braking system)
* Emergency release device for spring-loaded cylinders
* Tire pressure monitoring with display option in the truck via EBS signal – no truck-side installation required
* Drum brakes
* 4 x 11 t Gigant axles
* Air suspension with manual lowering at the rear
* Warning sign packages front and rear
* SmartBord infotool installed with pressure sensors for displaying total axle load per axle group
* Reflective contour tape on the sides and rear
* Removable LED rotating beacon at the rear
* 15-pin power connector
* LED tail lights
* Straight drawbar with 50 mm towing eye and stepless height adjustment
* Front closed single plastic mudguards
* Rear straight steel mud flaps each with splash guards (spray suppression)
* Side underrun protection
* Front extension in front of the bogie platform approx. 520 mm with 45° corners and 3 storage compartments including lockable hinged covers (covers open to the rear)
* Chassis made of high strength fine-grain steel
* Floor over bogie platform made of 50 mm softwood and 60 mm on the lowbed platform
* Outer planks of the loading ramps made of 50 mm hardwood
Guodpfjxmpyksx Aacea
* Lashing package consisting of: 2 lashing eyes 6.4 t front left and right on the main frame of the bogie platform, side front and rear each 1 pair of 13.4 t lashing rings on the outer frame, and side each 1 pair of 10 t lashing rings, swiveling and lowerable, loadable in all directions and recessed into the outer frame, bolted 5 t lashing rings to the outer frames of the wheel wells (2 at the front wheel well and 1 at the rear), 2 pairs of 6.4 t lashing rings at the side in the excavator arm rest
* 11 pairs of folding outriggers for 3 m total width (except on rear slope)
* Storage compartment (L = 2,470 x W = 570 x H = 250 mm) for the widening planks made of steel sheet, mounted transversely to the loading platform in front of the 1st rear axle
* Excavator arm rest above the rear axle to the end of the drive-up slope, approx. 2,300 x 740 x 190 mm
* Each side with 2 wheel wells approx. 640 mm wide – front 340 mm deep, rear 220 mm deep – with sliding covers (storage for the covers on the front of the bogie platform) for the transport of wheel loaders with a wheelbase of 3,100 – 3,640 mm
* Mechanical drop-down supports at the rear
* Hydraulic folding ramps with hydraulically extendable tip, approx. 4,650 x 720 mm
* Hydraulic lateral ramp shift
* Loading area above the slewing ring: approx. 2,990 x 2,520 mm
* Rear loading area: approx. 6,780 x 2,520 mm, loaded height approx. 890 mm +/- 20 mm (incl. 860 mm drive-up slope)
* Chassis, bogie, folding outriggers, rear drop supports and loading ramps hot-dip galvanized
* Axles, air tanks and drawbar painted black
* Tires: 235/75R17.5
* Vehicle is hot-dip galvanized
* New vehicle with manufacturer’s warranty
* Subject to errors and interim sale
* Immediately available ex Egestorf

Объявление было переведено автоматически. Возможны ошибки перевода.