Low loader trailer

MÜLLER-MITTELTAL T3 Tiefl., verz., Baggerstiel, hydr. Klapprampen

* T 3:
* EBS braking system
* Emergency release device for spring accumulator cylinders
* Drum brakes
* 3 x 11 tons BPW Eco axles
* Parabolic springs
* Mechanical axle compensation at the rear
* Side impact protection
* Swivel supports at the rear of the chassis frame
* Mechanically adjustable warning sign packages at the front and rear
* Front axle with closed plastic mudguards and rear axle with straight, galvanized steel splash guards, each with splash protection
* Reflective contour strip on the side and at the rear
* Folding cover (hot-dip galvanized) for the toolbox in the turntable platform
* Toolbox made of galvanized sheet steel, approx. 650 x 300 x 600 mm - black powder-coated - on the side, under the chassis
* 15-pole power connector
* LED lighting 12 / 24 V
* LED rotating beacon (removable) at the rear
* Drawbar with 40 mm drawbar eye and height adjustment via tension spring and locking mechanism
* 4 lashing points on each side (but no lashing bars included) with simultaneous lashing capability
Csdpfetplwfex Adqjri
* La-Si package consisting of: 2 lashing points (6.4 tons) at the front left and right on the main frame of the turntable platform
* 5 pairs of UVV lashing rings, swiveling and lowerable
* Loadable in all directions and recessed in the corners of the outer frame, 13.4 tons, otherwise 10 tons
* 6 pairs of mechanical folding outriggers for a total width of 3 m (but not in the rear slope)
* Extension boards under the loading area, stored in a storage compartment
* Excavator arm rest over the rear axle up to the end beam, approx. 2,100 mm long (2 pairs of 6.4 ton lashing points on the side in the excavator arm rest)
* Hydraulic folding ramps (approx. 4,650 x 720 mm) with hydraulically extendable front section and load-holding check valves, hydraulic lateral ramp adjustment
* Hydraulic flow divider in the trailer (for hydraulic pump output in the truck of over 40 l/min up to max. 140 l/min), dual-line hydraulics
* Loading area above the slewing ring: approx. 1,960 x 2,520 mm
* Rear loading area: approx. 6,500 x 2,520 mm (incl. 860 mm access slope)
* Loading height when loaded: approx. 860 mm +/- 30 mm, leveling system
* Chassis, turntable, folding outriggers, rear supports and access ramps hot-dip galvanized.
* Axles, springs, drawbar, air tank, etc. painted in black.
* New vehicle with manufacturer's warranty
* Errors and prior sale excepted
* Delivery from approx. week 50/2026

Объявление было переведено автоматически. Возможны ошибки перевода.